1、【求助】鈑金設計中,form中punch和die有什麼區別呀?謝謝
這在黃聖傑的鈑金一書上就有講,punch是沖頭,沖在平板上會產生凸型,die是母模,沖在平板上會是凹型。
2、請問沖壓模具PUNCH和DIE INSERT 的配合間隙。 沖壓的材料是:紅銅,片厚是0.5,最佳的配合間隙是多少?
與用在哪裡的一般區別不大,主要還是看材質,材質決定間隙。紅銅取料厚的4%-5%,單邊間隙版哦。至於你是用權什麼材質做的零件,那隻是增加了零件的壽命,間隙不受影響,也就說,PUNCH 和DIE ,單邊間隙等於0.5*0.05=0.025。
3、punch form 與 die form 有什麼區別
區別是:
punch form 指的是凸模形式。
die form 指的是模具形式。
例句辨析:
punch form
1、Such fabrics require special needles that punch beyond the surface to form loopson one side.
這些織物需要特殊的刺針以刺透織物,在織物表面形成線圈。
2、Two Different Methods of Acupuncture Treatment of Idiopathic Clinical Study ofFacial Paralysis Such fabrics require special needles that punch beyond the surfaceto form loops on one side.
兩種不同針刺方法治療特發性面神經麻痹的臨床研究這些織物需要特殊的刺針以刺透織物,在織物表面形成線圈。
3、When growing silicide electrode, the thick silicide can punch through the shallowsource and form Ohm contact with body below that has high dopant concentration.
然後生長硅化物電極,厚的硅化物穿透源區淺結與下面高濃度的體區形成歐姆接觸。
die form
1、Die cast into form with beautiful appearance.
壓鑄成型,外形美觀。
2、The effects of solvent percentage, die form, screw-combining mode, watertemperature in die and screw on proct density, die pressure and torque wereanalyzed by the range analysis method.
用極差分析方法分析了溶劑比、模具形式、螺桿組合方式、模具水溫、螺桿水溫對產品密度、機頭壓力和扭矩的影響。
3、The influences of the particle size, pressure of die form, heat treatment temperature and the species of raw material on the component and mechanical properties of electric heating carbon/ ceramic composites was studied.
本文系統研究了陶瓷原料的種類及粒徑大小、成形壓力、燒結溫度以及不同填料等工藝條件對炭/陶復合材料的微觀組成及力學性能影響。
4、模具專業術語日文版怎麼寫,誰幫幫我。
這么多一下子不好回答,另外聯系吧!